Philips Sopho 2000 IPS User Manual page 373

A
CMAA Specify the sending method of calling number
to the 911 Sender trunk.
CM35 Set the trunk route that no answer signal ar-
rives from the distant office for outgoing con-
nection.
Specify incoming connection signaling.
NOTE: DTI card must be set to Wink Start.
ODT card and COT card must be set
to Ring Down. Enhanced 911 will
not function if ODT card is set to
Wink Start.
Provide SMDR/Centralized Billing for outgo-
ing call.
Specify sender start condition.
NOTE: Digital and Analog Tie Lines are set
to Wink Start. Analog Loop Start
Lines are set to Timing Start.
Specify the trunk seizure pattern.
Provide the trunk route with Enhanced 911.
Specify the sending method of calling number
to the network.
Assign the Area Code Development Pattern
number for maximum digit analysis.
B
DESCRIPTION
• Y=07 Sending method of calling number
(1) 04-15, 20-31: AP No. assigned by CM05
(2) 3: Enhanced 911
• Y=04 Answer Signal from distant office
(1) 00-63: Trunk Route No.
(2) 3: No Answer signal (Polarity Reversal is
ignored)
• Y=09 Incoming connection signaling
(1) 00-63: Trunk Route No.
(2) 03 : Wink Start
15 : Ring Down
• Y=14 SMDR for outgoing call
(1) 00-63: Trunk Route No.
(2) 1 : To provide
• Y=20 Sender start condition
(1) 00-63: Trunk Route No.
(2) 00 : Wink Start
15 : Timing Start
• Y=36 Trunk seizure pattern
(1) 00-63: Trunk Route No.
(2) 0: After dialing maximum number of digits
• Y=38 Enhanced 911
(1) 00-63: Trunk Route No.
(2) 0: Available
• Y=129 Sending method of calling number
(1) 00-63: Trunk Route No.
(2) 3: Enhanced 911
• Y=76 Area Code Development Pattern
(1) 00-63: Trunk Route No.
(2) 00-07: Area Code Development Pattern
– 355 –
ENHANCED 911
DATA
No. 0-7
NWA-008845-001 Rev.5.0
32ch1006.fm