Tie Lines - Philips Sopho 2000 IPS User Manual

TIE LINES

PROGRAMMING
START
CM10 Assign a trunk number for the ODT card to the
required LEN.
NOTE:
CM14 Assign a trunk number for the ODT card to the
required LEN.
[Series 3200 R6.2 software required]
NOTE:
CM20 Assign a trunk route access code to each Tie
Line trunk route.
CM30 Assign a trunk route and tenant number to each
trunk.
CM35 Assign trunk route data to the trunk route num-
ber assigned by CM30 Y=00.
NOTE 1:
NOTE 2:
A
DESCRIPTION
The trunk number must be assigned
to the first LEN (Level 0) and the
second LEN (Level 1) of each LT
slot.
The trunk number must be assigned
to the first LEN (Level 0) and the
second LEN (Level 1) of each LT
slot.
All circuits in one ODT card must be
set to same type interface (2-wire or
4-wire).
For Type II signaling by 4ODT
card, set JP1-4 switch to DOWN.
(1) 000-763: LEN
(2) D000-D255: Trunk No.
(1) XX ZZZ: LEN
XX : 00-59: FP No.
ZZZ: 000-127: Port No.
(2) D000-D255: Trunk No.
• Y=0-3 Numbering Plan Group 0-3
(1) X-XXXX: Access Code (81/82)
(2) 100-163: Trunk Route 00-63 (01/02)
• Y=00
(1) 000-255: Trunk No.
(2) 00-63: Trunk Route No. (01/02)
• Y=01
(1) 000-255: Trunk No.
(2) 00-63: Tenant No. (00/00)
• Y=105 2-wire E&M/4-wire E&M Trunk
(1) 00-63: Trunk Route No.
(2) 0 : 2-wire E&M Trunk
1 : 4-wire E&M Trunk
• Y=104 Polarity of E&M Trunk
(1) 00-63: Trunk Route No.
(2) 1 : E wire (Open), M wire (Open), Signal-
ing (Type V)
2 : E wire (Ground), M wire (Battery),
Signaling (Type I)
3 : E wire (Ground), M wire (Ground),
Signaling (Type V/Type II)
[Series 3300 software required]
– 688 –
TIE LINES
DATA
NOTE 2
NWA-008845-001 Rev.5.0
32ch1011.fm