Philips Sopho 2000 IPS User Manual page 30

(3) Card Number of PB receiver (PN-8RST) <E201-E215>
(a) The card number should be assigned to the FP No. 00-03 as follows.
For FP No. 00: E201-E203
For FP No. 01: E204-E207
For FP No. 02: E208-E211
For FP No. 03: E212-E215
(b) For the other FP No. than above (a), the card number (E201-E215) can be assigned to without
limit as shown above (a).
(c) The card numbers (E200, E216-E230) are used for MP built-in DTMF Receiver. For details,
refer to PB (DTMF) RECEIVER NUMBER.
(4) Card Number of External Equipment Interface (PN-DK00) <E800-E831>
(a) The card number should be assigned to the FP No. 00-03 as follows.
For FP No. 00: E800-E807
For FP No. 01: E808-E815
For FP No. 02: E816-E823
For FP No. 03: E824-E831
(b) Do not assign the card number to the other FP No. than above (a).
(c) This data is not effective for a remote site of Remote PIM over IP system.
(d) Circuit No. 3 of E831 is used for built-in External Equipment Interface of MP card by setting
CM44.
(5) Card Number of External Key Interface (PN-DK00) <E900-E963>
(a) The card number should be assigned to the FP No. 00-03 as follows.
For FP No. 00: E900-E915
For FP No. 01: E916-E931
For FP No. 02: E932-E947
For FP No. 03: E948-E963
(b) Do not assign the card number to the other FP No. than above (a).
(c) This data is not effective for a remote site of Remote PIM over IP system.
(d) Circuit No. 3 of E963 is used for built-in External Key Interface of MP card by setting CM61.
CONDITIONS ON CARD/TERMINAL NUMBER ASSIGNMENT BY CM14
Page 14
– 12 –
INTRODUCTION
NWA-008845-001 Rev.5.0
32ch0001.fm
JULY/01/2006