Caller Id Display - Philips Sopho 2000 IPS User Manual

CALLER ID DISPLAY

PROGRAMMING
In addition to Automatic Number Identification (ANI) or Caller ID Class, assign the following data.
START
CM08 Specify the duration of displaying the name
when the incoming call is answered/the select
key for Calling Number Display and Calling
Name Display or CID key is pressed.
[Series 3300 software required]
CM90 Provide the D
for displaying the ANI or Caller ID.
END
To store the calling party name list in the MP card and display the name on D
do the following programming.
NOTE:
This programming is effective only when the caller ID (name) is not stored in the CIR card by
CMDB or a calling party name is not received from network.
START
CM12
Assign Service Restriction Class A to each
station.
CM15 Allow Calling Name Display for incoming
trunk calls in Service Restriction Class A
assigned by CM12 Y=02.
CM35 Provide the trunk route with Calling Name
Display for incoming calls.
A
DESCRIPTION
term
with a Caller ID Display key
DESCRIPTION
(1) 537
(2) 0 : Until call is finished/key is pressed
again
1 : 6 seconds
• Y=00
(1) My Line No. +
(2) F5010: Caller ID Display
• Y=02
(1) X-XXXXXXXX: Station No.
(2) XX ZZ
XX: 00-15 : Service Restriction Class A
• Y=136
(1) 00-15: Service Restriction Class A as-
(2) 0 : Calling Number Display
1 : Calling Name Display
• Y=156
(1) 00-63: Trunk Route No.
(2) 0 : 1000-Slot Memory Block No. 3
1 : 1000-Slot Memory Block No. 2, 3
3 : Not provided
– 186 –
CALLER ID DISPLAY
DATA
,
+ Key No.
term
for incoming trunk calls,
DATA
signed by CM12 Y=02
NWA-008845-001 Rev.5.0
32ch1003.fm
JULY/01/2006