Ap Initialization (Pn-Ap00-B With Ap00 Program) - Philips Sopho 2000 IPS User Manual

AP INITIALIZATION (PN-AP00-B WITH AP00 PROGRAM)

This section explains the data assignment to make the AP active.
You can skip the data assignment explained on this section, if one of the following AP related features has
been activated; Station Message Detail Recording (SMDR), Message Center Interface (MCI), Property
Management System (PMS), or Hotel Printer. You can distinguish whether the AP is active or not by the
RUN lamp indication. The RUN lamp flashes on green color when the AP is in active.
When you install the AP00 for the first time, you should assign the data shown below.
START
CM05 Assign an AP number to the AP00 card.
The AP number must match the SENSE switch
setting on the AP00 card.
On the AP00 card, set SW1 switch as shown
below.
SW 1
ON
CMD101 Load the initial data into the AP00 card.
On the AP00 card, set the SW1 switch as
shown below:
SW 1
ON
END
DESCRIPTION
4
3
: POSITION TO BE SET
2
1
AP OFF LINE
4
3
: POSITION TO BE SET
2
1
AP INITIALIZATION (PN-AP00-B WITH AP00 PROGRAM)
• Y=0
(1) 04-15, 20-31: AP No.
(2) 04: AP00 card
INITIAL
SW1-4 should be set as follows;
ON : The AP No. is 04-15
OFF: The AP No. is 20-31
(1) 0000
(2) CCC
SW1-4 should be set as follows;
ON : The AP No. is 04-15
OFF: The AP No. is 20-31
– 768 –
HOTEL SYSTEM PROGRAMMING
DATA
NWA-008845-001 Rev.5.0
32ch2001.fm
JULY/01/2006