Setting Up Alarms And Warnings - Cisco D9865 Installation And Configuration Manual

Chapter 5 Setup and Monitoring via Web GUI

Setting Up Alarms and Warnings

To Set Up Alarms
Proceed as follows to set up the alarms:
From the user interface of the D9865, choose System Settings > Alarms > Setup. The Setup - Alarm
Step 1
Setup page is displayed.
The Alarm Setup area displays a list of alarm/fault messages. For more information on alarm messages,
Step 2
refer to
From the Enable/Disable drop-down list, choose Yes to report the alarm message. Choose to No and the
Step 3
fault won't be reported.
Set Trap to Yes and the SNMP trap message will be sent to the trap destination; otherwise the fault
Step 4
message will be ignored.
Note
Click the Trap Configuration link to view and/or modify trap destinations. The link will open the SNMP
Step 5
page. For more information, refer to
Step 6 Click Apply.
OL-31085-01
Alarm Messages, page 6-1.
This is for D9865D only.
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
Setting Up SNMP and Trap Destinations, page
Viewing the Alarm/Warning Status
5-38.
5-43