Setting Up Alarms And Warnings - Cisco D9858 Installation And Configuration Manual

Setting up Alarms and Warnings

To Set Up Alarms
1 From the user interface of the D9858, choose System Settings > Setup. The
Alarm Setup page is displayed.
2 Check the Enable Alarm/Warning Front Panel Reminder check box and the
highest priority alarm flashes on the LCD display for a two-second interval every
10 seconds. The alarm will continue to flash periodically until it is either cleared
or the Enable Alarm/Warning Front Panel Reminder is de-selected.
3 Check the Enable Video Cutoff on Alarm Condition check box to cut off the
video output if any enabled alarm is active on the receiver. When video is cut off,
there will be no horizontal or vertical synchronization on the output. This is
useful for downstream redundancy switching by detecting a loss of video signal.
4 Click the Trap Configuration link to view and/or modify SNMP trap
destinations. The link will open the SNMP page. For more information, see
Setting up SNMP Information and Trap Destinations (on page 238).
Configuring System Settings
243