Cisco D9865 Installation And Configuration Manual page 165

Chapter 6 Service and Maintenance
Alarm Set Message
Shutdown WDOG task:
Event watchdog
Secondary WD has
expired
System System Startup
Startup
LMI Setup LMI SDRAM
exhaust test failed
Param DB NVS flushing
Storage ignored
Param RAM flush to NVS
Storage failed
Param DB Factory Reset
Storage failed
Flash RECORD: init
Storage failed
Flash RECORD
Storage MANAGER:
Record contents
check error,
erasing all
Flash RECORD: sector
Storage setup check error,
erasing sector
LNB PS LNBPS: No Load
LNB PS LNBPS: Over
Temperature
OL-31085-01
Cause Remedy
The software detected Clear alarms, reset the
an error in operation. unit, and notify Cisco
customer support if the
problem persists.
Restarted the D9865 None. It will
Satellite Receiver. automatically reset after
1 second.
DDR RAM on LMI bus Clear alarms, reset the
not working due to a unit, and notify Cisco
hardware issue. customer support if the
problem persists.
Non-volatile storage Clear alarms, reset the
system failed to fully unit, and notify Cisco
update due to a customer support if the
hardware issue. problem persists.
Non-volatile storage Clear alarms, reset the
system failed to fully unit, and notify Cisco
update due to a customer support if the
hardware issue. problem persists.
Non-volatile storage Clear alarms, reset the
system failed during unit, and notify Cisco
factory reset. customer support if the
problem persists.
Non-volatile storage Clear alarms, reset the
system corrupted due to unit, and notify Cisco
a hardware issue. There customer support if the
is a possible loss of problem persists.
configuration.
NVS corruption and Clear alarms, reset the
loss of configuration unit, and notify Cisco
data due to a hardware customer support if the
issue. problem persists.
NVS Corruption and Clear alarms, reset the
loss of sector data due to unit, and notify Cisco
a hardware issue. customer support if the
problem persists.
LNB power overload Clear alarms, check
due to a hardware or LNB and wiring. Notify
wiring issue. Cisco customer support
if the problem persists.
LNB power overload Clear alarms, check
due to a hardware or LNB and wiring. Notify
wiring issue. Cisco customer support
if the problem persists.
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
Alarm Messages
Severity Clear Message
Major None.
Minor Backup/Restore System
Startup.
Major LMI Video SDRAM
exhaust test passed
Major DB flushing completed
Major DB flushing completed
Major DB Factory Reset
completed
Major RECORD: init done
Major
Major
Minor LNBPS: Normal
Minor LNBPS: Disabled
6-7