To Set Up Warnings - Cisco D9865 Installation And Configuration Manual

Viewing the Alarm/Warning Status

To Set up Warnings

Proceed as follows to set up the warnings:
From the Setup - Alarm Setup page, click the Warning Setup link at the bottom left hand corner of the
page. The Setup - Warning Setup page is displayed.
The Warning Setup area displays a list of alarm/fault messages. For more information on warning
Step 7
messages, refer to
From the Enable/Disable drop-down list, choose Yes to report the warning message. Choose No and the
Step 8
fault will not be reported.
From the Trap drop-down list, choose Yes and the SNMP trap message will be sent to the trap
Step 9
destination; otherwise the fault message will be ignored.
Note
Click the Trap Configuration link to view and/or modify trap destinations. The link will open the SNMP
Step 10
page. For more information, refer to
Step 11 Click Apply.
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
5-44
Warning Messages, page
This is for D9865D only.
6-10.
Setting Up SNMP and Trap Destinations, page
Chapter 5 Setup and Monitoring via Web GUI
5-38.
OL-31085-01