Cisco D9865 Installation And Configuration Manual page 71

Chapter 4 Setup and Monitoring via On-Screen Display
Selection
Menu transparency
IR remote
Date Format
Time format
Time offset
Actual Lock Level
Adv Admin
OL-31085-01
Options
None, 25%, 50%, 75%,
90%
Enable
Disable
YYYY/MM/DD,
DD/MM/YYYY,
MM/DD/YYYY
24 Hr, 24 Hr
SuspendZero, 12 Hr, 12
Hr SuspendZero
Adjusted in one hour
increments, from -12:00
to +13:00, and GMT.
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
Description
Set the transparency level of the
menus displayed on-screen.
For example, if set to None,
menus are solid and the video
appears behind the menus. If set
to 25%, menus are clear and the
video is visible through the
menus.
Set to Enable to control the
receiver using the remote
control. By default, the receiver
is shipped with the remote
control enabled.
The EPG functions are
Note
only available using the
IR remote control.
Set to Disable if you want to
disable the remote control and
use the front panel controls only.
Current date information is
displayed in the Active Alarm
and Active Warning screens.
Time information is displayed in
the Active Alarm and Active
Warning screens.
Time information is normally
broadcast as part of the
transmitted digital signal, and is
usually the broadcaster local
time relative to Greenwich Mean
Time (GMT).
Displays the time zone offset
instead of the true local time. If
the current broadcast time is not
your local time, you must change
this time setting.
Displays the current lock level.
Displays the Advanced
Administration screen. For more
information, see Changing the
Lock Level Password,
page 4-38.
Setup Menu
Default
None
Enable
YYYY/MM/D
D
24 Hr
+05:30
4-37