Setting Up The Preset / Lnb - Cisco D9865 Installation And Configuration Manual

Chapter 4 Setup and Monitoring via On-Screen Display
Selection
DiSEqC Switch
Signal Lock
Signal Quality
Signal Level
If you enter an invalid frequency setting or a setting that does not correspond to the selection, a pop-up
Note
message such as "Input value out of range" is displayed.
Step 3 Press the green button (Save) to save and apply the settings to the receiver.

Setting up the Preset / LNB

The Preset/LNB Setup sub-menu allows you to select or configure up to 64 network presets. Your
receiver may be shipped pre-configured with a number of network presets. You can configure the
network preset to use one of 10 LNB configurations.
Proceed as follows to set up the preset/LNB settings:
From the Tuning / Preset screen, press the yellow button (Preset) to set up the Preset/LNB.
Step 1
Step 2 The following table describes each of the available options:
OL-31085-01
Options Description
Off Selects a port on the LNB switch
(if used)
A to P
Indicates signal synchronization
status.
Indicates the quality of the
received signal, associated with
the Bit Error Rate, in the range
from 0 to 100.
Indicates the strength of the
received signal in the range from
0 to 100.
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
Setup Menu
Default
Off
4-17