Setting Up The Satellite Dish - Cisco D9865 Installation And Configuration Manual

Chapter 4 Setup and Monitoring via On-Screen Display
LNB Power Settings
The following table displays the LNB Power settings:
LNB Power Settings
Off
18-H
13-V
H-NIT
V-NIT

Setting Up the Satellite Dish

The Dish Setup menu provides graphical assistance for dish positioning. This menu can be set to two
modes: User Mode (default) or Installer Mode. The User mode allows you to select from stored Satellite
Numbers, which are stored satellite locations, as stored in the dish motor, but does not provide any dish
control.
Proceed as follows to set up the dish:
From the Setup Menu, select Dish Setup and press OK. By default, the Dish Setup screen is displayed
Step 1
in User mode.
OL-31085-01
NIT Contains
Not received
H
V
Not received
H
V
Not received
H
V
Not received
H
V
Not received
H
V
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
Output LNB Voltage
Off
Off
Off
18 volts
18 volts
18 volts
13 volts
13 volts
13 volts
18 volts
18 volts
13 volts
13 volts
18 volts
13 volts
Setup Menu
4-21