Cisco D9865 Installation And Configuration Manual page 167

Chapter 6 Service and Maintenance
Alarm Set Message
Boot Host APP Invalid
MPE alarm Data lost, transport
error
MPE alarm Data lost, CRC
error
MPE alarm Data lost, CC error CC error detected in
MPE alarm Data lost, buffer
overflow
MPE alarm Data lost, bad
sections
MPE alarm Data lost, MPE
capacity exceeded
MPE alarm MPE capacity is
reached.
LEC LEC Table
Timeout Missing/timeout:
channels currently
unavailable
OL-31085-01
Cause Remedy
Application software Clear alarms, reset unit,
cannot be read from and notify customer
memory correctly due support if the problem
to a hardware issue. persists.
Transport error Verify that the uplink is
indicator is set in the in good condition.
transport stream.
CRC error detected in Verify that the uplink is
MPE stream. in good condition.
Verify that the uplink is
MPE stream. in good condition.
Buffer overflow Reduce MPE rate.
detected in MPE stream.
Bad section data Verify uplink is in good
detected in MPE stream, condition and/or reduce
due to original data or MPE rate.
overflow issue.
Bit rate controller Reduce MPE rate.
dropping data due to
CPU load limitations.
Unit is busy processing Reduce service load.
or handling other
services.
LEC table is missing or Verify that the uplink is
not received due to the sending LEC tables.
LEC table missing in
the signal.
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
Alarm Messages
Severity Clear Message
Major
Major None.
Major None.
Major None.
Major None.
Major None.
Major None.
Major None.
Major LEC received
6-9