Setting Up Snmp And Trap Destinations - Cisco D9865 Installation And Configuration Manual

Setting Up IP Information
c.
d.
e.
The Multicast Filtering Addresses section lists the multicast destination IP addresses. To add a new
Step 5
address, click Add. The following is displayed:
a.
b.
Click Apply.
Step 6

Setting Up SNMP and Trap Destinations

Proceed as follows to configure the SNMP settings:
From the user interface of the D9865, choose System Settings > System > IP Settings > SNMP. The
Step 1
SNMP page is displayed.
In the Read Community String and the Write Community String fields, enter public or a custom
Step 2
string. The SNMP Community Read/Write is used when communicating with a device within an SNMP
environment. These commands allow you to set the password to read and write data to a device to display
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
5-38
In the Gateway Address field, enter the network gateway address used to expose the receiver to a
WAN.
Click Add.
To remove an address entry, click the entry radio button and click Delete.
In the Multicast Filter Address field, enter the multicast filter address and click Add.
To remove an address entry, click the entry radio button and click Delete.
Chapter 5 Setup and Monitoring via Web GUI
OL-31085-01