Cisco D9865 Installation And Configuration Manual page 169

Chapter 6 Service and Maintenance
Warning Set Message
Memory Usage Host Excessive
(stack/partition)
memory usage
MPE near capacity Approaching current
capacity
Ethernet MAC MAC configuration
Failure failed
Ethernet PHY Marvel switch
Failure configuration failed
Ethernet Port 1 or ETH Port 1 or 2 Link
Ethernet Port 2 Down
FW: Resource Use Memory or List Near
PRI Full
Backup Operation Backup Active
State
Backup Failure Internal Error
Reason
Backup Failure FTP Failed
Reason
Restore Failure Not Accepted
Reason
Restore Failure Bad Content
Reason
OL-31085-01
Cause
SW exceeding
allowable memory
usage due to a software
issue.
Decoder is busy
processing or handling
other services and it is
approaching the limit of
safe CPU load for MPE
processing.
Errors, such as a Fatal
Bus Error, due to a
possible hardware issue.
Related to MII register
read/write failures, due
to a possible hardware
issue.
Ethernet port 1 or 2 is
not connected.
Software exceeding
allowable usage of
internal constructs, due
to a possible software
issue.
Backup operation
started.
Software error occurred
due to a possible
software issue.
FTP failed due to a
possible software issue.
Software error occurred
due to a possible
software issue.
Software error occurred
due to a possible
software issue.
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
Remedy Clear Message
Clear warnings, reset Normal (stack/partition)
the unit, and notify memory usage
customer service if the
problem persists.
Reduce or stop MPE None.
service content.
Clear warnings, reset Failure cleared
the unit, and notify
customer service if
problem persists.
Clear warnings, reset PHY failure monitoring
the unit, and notify reset
Cisco customer support
if the problem persists.
Connect Ethernet port 1 ETH Port 1 or 2 Link
or 2. Up
Clear warnings, reset None.
the unit, and notify
Cisco customer support
if the problem persists.
None. Backup Complete
Clear warning, reset the Auto reset after timeout
unit, and notify Cisco
customer support if the
problem persists.
Check FTP Auto reset after timeout
configuration, reset
unit, and notify Cisco
customer support if
problem persists.
Clear warning, reset the Auto reset after timeout
unit, and notify Cisco
customer support if the
problem persists.
Clear warning, reset the Auto reset after timeout
unit, and notify Cisco
customer support if the
problem persists.
Warning Messages
6-11