Setting Up Ip Routing - Cisco D9865 Installation And Configuration Manual

Chapter 5 Setup and Monitoring via Web GUI

Setting Up IP Routing

Proceed as follows to configure the IP Routing settings:
From the user interface of the D9865, choose System Settings > System > IP Settings > IP Routing.
Step 1
The IP Routing page is displayed.
Step 2 From the MPE Data Filter Mode drop-down list, choose whether all the MPE data is forwarded
(Forward All) via the Gateway. It can forward up to 5 PIDs at the maximum bit rates shown in the
following table. Otherwise, select Forward None.
MPE Bit Rate
Multicast
Unicast
From the MPE Optimization drop-down list, choose High Bitrate (default) to accumulate the IP
Step 3
packets before they are processed in short bursts, increasing the allowable bit rate of MPE data. Choose
Low Jitter to emit the IP packets in a constant stream, resulting in low latency.
The Static Unicast Routing area displays the static unicast routing addresses for the MPE data. To add
Step 4
a new address, click Add. The following is displayed:
a.
b.
OL-31085-01
No Decoding
30 Mbps
20 Mbps
In the Destination IP Address field, enter the IP address participating in a Network environment.
In the Mask field, enter the subnet mask for its participation in a Network environment, from 8 to 32.
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
5 Mbps SD Video 20 Mbps HD Video
Decoded Decoded
20 Mbps 15 Mbps
15 Mbps 10 Mbps
Setting Up IP Information
5-37