Adjusting The Satellite Position In Installer Mode; Changing The Satellite Position In User Mode; Adjusting The Satellite Position Using Signal Tones - Cisco D9865 Installation And Configuration Manual

Chapter 4 Setup and Monitoring via On-Screen Display

Adjusting the Satellite Position in Installer Mode

To adjust the satellite position, the DiSEqC must be set to Enable.
Step 1 On the Dish Setup screen, press the yellow button (Installer) to select Installer mode.
Ensure the DiSEqC is set to Enable and then press the green button (Adj Dish).
Step 2
Press the red or yellow button for fine west and east dish adjustment. Press the green or blue button for
Step 3
coarse east and west dish adjustment.

Changing the Satellite Position in User Mode

To select a new satellite position on the Dish Setup menu:
Step 1 Use the
Step 2 Enter the pre-stored satellite number you want to use in the range from 1 to 255, and press OK.
Press
Step 3
Press
Step 4
position.
Step 5 Press MENU to move to the previous menu, or EXIT to go to video.

Adjusting the Satellite position using Signal Tones

Dish alignment can be done using the audible signal adjustment tone. The characteristics of the signal
tone are shown in the table below. Align the dish to achieve signal lock and then best signal quality.
The signal adjustment tone automatically outputs as PCM audio type only, regardless of the Digital
Note
Audio Preference set in Audio Setup.
OL-31085-01

buttons to move to Satellite Number and press OK.

to move down to User Action and press OK.

to choose Goto Satellite and press OK. The receiver is now tuned to the selected satellite
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
Setup Menu
4-25