Setting Up Audio - Cisco D9865 Installation And Configuration Manual

Chapter 5 Setup and Monitoring via Web GUI

Setting up Audio

Proceed as follows to set up the audio:
From the user interface of the D9865, choose Audio & Video > Audio Setup/Status. The Audio
Step 1
Setup/Status page is displayed.
Step 2 Choose the compressed audio type from the Digital Audio Setting drop-down list (PCM, Dolby Digital,
Compressed). For more information on the effects of Dolby Audio Preference setting on audio outputs,
based on the type of audio being decoded, see
From the Stereo/Mono drop-down list, choose the audio mode, which configures how audio received on
Step 3
the audio input is handled.
Choose Stereo (Left and right channels are output on L and R respectively), Mixed (Left and right
channels are combined and output on both L and R), L-Mono (Left channel is output on L and R), or
R-Mono (Right channel is output on L and R).
From the DRC Mode drop-down list, choose RF Mode or Line Mode. RF Mode is normally used for
Step 4
analog cable modulators, when limited dynamic range is desired. Line Mode is used when full dynamic
range is allowed.
Step 5 From the PMT Audio Source drop-down list, choose the PMT source for the audio channel (None or
AUD1 to AUD64).
The Volume adjustment for the audio channel ranges from 0 to 60. You can enter a value or use the
Step 6
provided slider to adjust the volume.
The Audio Status area displays the following information:
Step 7
Audio Status
Audio Format
Bit Rate (Mbps)
Sampling Frequency (Hz)
Buffer Level (Bytes)
OL-31085-01
Description
The received audio channel format (MPEG, Dolby Digital, AAC,
HEAAC or Dolby Digital Plus).
Audio bit rate of the received audio channel, in Mbps.
The audio sampling frequency (32, 44.1, or 48 Hz).
The audio input buffer level, in bytes.
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
Digital Audio Preference Settings, page
Setting up the Video
4-34.
5-33