Setting Up Si Receive Parameters - Cisco D9865 Installation And Configuration Manual

Chapter 5 Setup and Monitoring via Web GUI

Setting up SI Receive Parameters

Proceed as follows to setup the SI Receive parameters:
From the user interface of the D9865, choose Input > Satellite > Tuning Setup > SI Receive Setup.
Step 1
The SI Receive Setup page is displayed.
From the Acquisition Mode drop-down list, select the mode used to build channel lists from allowed
Step 2
service lists. The selections are Auto, Basic, or Custom. The default is Basic.
If you choose Custom, click Configure Custom SI Recv and the Configure Custom SI Recv window
opens:
Step 3 From the Frequency Tuning Mode drop-down list, choose whether the receiver is to be tuned to the
received signal using the NIT or User Cfg (user configurations).
OL-31085-01
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
Setting Up Dish Pointing
5-13