Cisco D9865 Installation And Configuration Manual page 77

Chapter 4 Setup and Monitoring via On-Screen Display
Setting the Filter Mode
The filter mode sets the multicast forwarding for MPE data output.
Proceed as follows to set up the filter mode:
From the Advanced Setup screen, select IP Setup and press OK.
Step 1
The Filter Mode sets whether all the MPE data is forwarded (Forward All). It can forward up to 5 PIDs
Step 2
at the maximum bit rates shown in the following table. Otherwise, select Forward None.
MPE Bit Rate
Multicast
Unicast
Set the MPE Optimization setting. Select High Bitrate (default) to accumulate the IP packets before
Step 3
they are processed in short bursts, increasing the allowable bit rate of MPE data. Select Low Jitter to
emit the IP packets in a constant stream, resulting in low latency.
OL-31085-01
No Decoding
30 Mbps
20 Mbps
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
5 Mbps SD Video 20 Mbps HD Video
Decoded Decoded
20 Mbps 15 Mbps
15 Mbps 10 Mbps
Setup Menu
4-43