Configuring Noise Cutoffs - Cisco D9865 Installation And Configuration Manual

Setup Menu
Click the green button (Save) to save the changes.
Step 3
Editing/Deleting Trap Destinations
Proceed as follows to edit/delete trap destinations.
In the Trap Destination Setup screen, select the trap destination address you want to edit or delete and
Step 1
press OK.
Step 2 Press the blue button (Edit) to edit the address. Press the red button (Delete) to remove the address from
the Trap Destination list.
Step 3 If you pressed the blue button, you can edit the Trap Destination Address and Community String and
press the green button (Save) to save your changes.
If you pressed the red button (Delete), a warning message appears. Press OK to delete the selected trap
Step 4
destination entry. Otherwise, press Exit.

Configuring Noise Cutoffs

The Noise Cutoffs screen allows you to set the muting thresholds for both audio and video in the event
of a noisy signal.
Proceed as follows to configure the noise cutoffs:
Step 1 From the Advanced Setup screen, select Noise Cutoffs and press OK. A message appears confirming
that you want to edit the noise cutoffs.
Step 2 Select Yes to edit. Otherwise, select No.
Step 3 The following table describes each of the options:
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
4-50
Chapter 4 Setup and Monitoring via On-Screen Display
OL-31085-01