Setting Up Alarms And Warnings - Cisco D9865 Installation And Operation Manual

Setting up Alarms and Warnings

To Set Up Alarms and Warnings
Proceed as follows to set up the alarms and warnings:
1. From the Advanced Setup screen, select Alarms & Warnings and press OK.
2. Set whether alarms and warnings are to be displayed on-screen in AW Banner
(Enable or Disable).
Note: The alarms and warnings will only appear on-screen if the screen is
displaying video only. The AW Banner will not appear if EPG, Channel Banner
or on-screen menus are displayed.
3. The Active Alarms displays the number of currently active Alarms, and the
Active Warnings indicates the number of currently active Warnings.
4. Press the yellow button (Alarm) to configure the alarm settings. Press the blue
button (Warning) to configure the warning settings.
To configure the Alarm settings
1. From the Alarms & Warnings screen, press the yellow button (Alarm) on the
remote control.
2. Set the following alarm options:
Alarm Setting
Alarm Name
Alarm Enable
4035197 Rev C
Displays a list of the alarm/fault messages. You
can scroll through the list using the
When set to Yes, the alarm message will be
reported. When set to No, the fault will not be
reported.
D9865 Satellite Receiver Installation and Operation Guide
Description

buttons.
4-67