Configuring Captions - Cisco D9865 Installation And Configuration Manual

Setting up the Video
WSS Mode
Passthrough
Auto:Create
Auto:Modify
Suppress
Step 7 Check the Enable Banner Display check box to display the signal status and other information at the
top of the screen.
Step 8 The Video Status area displays the current video information, such as the aspect ratio mode, encoding
format, and bit rate.
Click Apply.
Step 9

Configuring Captions

Proceed as follows to set up the caption parameters:
From the user interface of the D9865, choose Audio & Video > Video Setup > Captions. The Captions
Step 1
page is displayed.
From the Preferred Closed Caption Mode drop-down list, choose the preferred closed caption mode.
Step 2
There are multiple in the stream. The default is Auto.
Note
The Status area displays the actual caption mode used. This is read-only.
Step 3
Click Apply.
Step 4
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
5-30
SA Custom is not supported when telecine video coding is enabled.
Description
Passes WSS (unmodified, as received by the D9865 receiver) on
VBI LIne 23 when present.
Creates WSS to output the correct aspect ratio, when performing
aspect ratio conversion, otherwise it is passed through.
Modifies WSS to output the correct aspect ratio, when performing
aspect ratio conversion, otherwise it is passed through.
Disables Line 23 VBI processing. WSS is not output on line 23.
Chapter 5 Setup and Monitoring via Web GUI
OL-31085-01