Cisco D9865 Installation And Configuration Manual page 50

Setup Menu
Selection
LO Select
(Sets a 22 kHz tone for
Ku-band dual LNB)
LO Freq 1
LO Freq 2
Crossover
LNB Power
(For more information,
see LNB Power
Settings, page 4-21
DiSEqC
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
4-16
Options Description
On Switches 22 kHz tone on.
Off Switches 22 kHz tone off.
Auto Sets 22 kHz tone to automatic.
If Downlink Freq < Crossover,
use LO Freq 1. The 22 kHz tone
is Off.
If Downlink Freq > Crossover,
use LO Freq 2. The 22 kHz tone
is On.
Enter number If C-band application, set to 5.15
GHz (default).
If Ku-band single LNB, enter LO
Freq. and set LO Freq 2 and
Crossover to 0.0.
If Ku-band dual LNB, enter LO
Freq 1, LO Freq 2 and Crossover.
Enter number Enter if Ku-band dual LNB
application. LO Freq 2 > LO
Freq 1.
Enter number Enter if Ku-Band dual LNB
application. Determines if LO
Freq 1 or LO Freq 2 is used for
tuning.
18-H For H polarization (18V).
13-V For V polarization (13V).
Off Use for external LNB power.
LNB power must be on if
DiSEqC is required.
H-NIT Initially applies the horizontal
polarization voltage, and then
follows the polarization based on
the NIT.
V-NIT Initially applies the vertical
polarization voltage, and then
follows the polarization based on
the NIT.
Enable Enables or disables Digital
Satellite Equipment Control,
Disable
level 1.2. This must be enabled
to control the DiSEqC switch.
LNB Power must be on to use
this setting. Refer to
http://www.eutelsat.com/satellit
es/4_5_5.html
information.
Chapter 4 Setup and Monitoring via On-Screen Display
Default
Off
10.75 GHz
0.0
0.0
18-H
Disable
for more
OL-31085-01