Cisco D9865 Installation And Configuration Manual page 114

Setting Up Dish Pointing
Options
Continuous West Movement
Continuous East Movement
Stop Move
Goto Absolute Position West
Goto Absolute Position East
Goto Reference
Goto Satellite
Store Satellite
Clear Limits
Store East Limits
Store West Limits
Calculate Position
None
From the DiSEqC drop-down list, choose to enable or disable the Digital Satellite Equipment Satellite
Step 4
Control, level 1.2.
Note
In the Absolute Position field, enter the absolute position of the satellite, in degrees. You can enter a
Step 5
value in the range from 0.0 to 75.0 degrees.
The Tuner Performance area is the same as the Tuner Performance section in the User Action mode.
Step 6
For more information, see above.
Click Apply.
Step 7
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
5-12
This must be enabled to control the DiSEqC switch. LNB Power must be on to use this setting.
Refer to http://www.eutelsat.com/satellites/4_5_5.html
Description
Moves the dish west until it reaches its limit. Ensure that the dish
can move to its limit without any obstructions.
Moves the dish east until it reaches its limit. Ensure that the dish can
move to its limit without any obstructions.
Stops movement of the dish.
Moves the dish to the Absolute west position set above.
Moves the dish to the Absolute east position set above.
Moves the dish to a reference defined by the dish motor
manufacturer.
Moves the dish to the selected pre-stored satellite position. Satellite
positions are stored in the dish motor, if supported, not in the
receiver.
Stores the current dish position as a Satellite Number, if supported
by the dish motor.
Clears the dish east and west limits stored in the dish motor.
Stores the current position as the east limit in the dish motor.
Stores the current position as the west limit in the dish motor.
Updates the position of the dish according to the current position.
For more information, refer to the dish manual provided by the dish
manufacturer.
No action is performed.
Chapter 5 Setup and Monitoring via Web GUI
for more information.
OL-31085-01