Viewing Input Status - Cisco D9865 Installation And Configuration Manual

Viewing Input Status

In the Crossover field, enter the internal threshold frequency used for selecting the LO1 or LO2
Step 7
frequency, depending on the current downlink frequency settings. This option is only used in dual-band
LNB applications. The default is 0.0 GHz.
From the DiSEqC drop-down list, choose to enable or disable the Digital Satellite Equipment Satellite
Step 8
Control, level 1.2.
Note
From the DiSEqC Switch drop-down list, choose a port on the LNB switch, if used (Off, A to P).
Step 9
Click Apply to Preset.
Step 10

Viewing Input Status

Proceed as follows to view the Input Status page:
From the user interface of the D9865, choose Input > Satellite > Input Status. The Input Status page
is displayed.
The Input Status page displays the active input port receiving the signal.
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
5-20
This must be enabled to control the DiSEqC switch. LNB Power must be on to use this setting.
Refer to http://www.eutelsat.com/satellites/4_5_5.html
Chapter 5 Setup and Monitoring via Web GUI
for more information.
OL-31085-01