Chapter 1 Quick Setup; About The Video Standard; Satellite Receiver Startup - Cisco D9865 Installation And Configuration Manual

Quick Setup
This chapter provides a quick setup of your D9865 Satellite Receiver. If you are unsure about which
receiver settings to use, contact your local service provider for assistance. This chapter presents the
following major topics:
•
•
•

About the Video Standard

The Video Standard used to operate the receiver is preset at the factory to either NTSC (525-line), or
PAL (625-line). Changing the Video Standard is normally required only when operating the receiver in
a network or jurisdiction that uses the alternate Video Standard, and/or when new (or different)
subscriber services are made available. Changing the Video Standard or resetting the receiver to the
default factory settings may cause TV video to display improperly.

Satellite Receiver Startup

Check your installation:
Step 1
Check that your receiver is correctly installed and connected to the satellite LNB antenna, to other A/V
equipment (as required) and to AC power.
This product plugs into a socket outlet. A socket outlet must be near this product, and must be easily
Note
accessible.
The product has a power switch (located on the rear panel). It may be used to turn off the receiver to
conserve energy.
Step 2 The application code version and APP appears on the receiver front panel while it is powering up. It takes
about 60 seconds for the receiver to completely power up. Once the receiver has completely powered up,
a flashing "." appears on the front panel.
Turning on the receiver: Press the DISPLAY button on the Remote Control or press the DISPLAY
Step 3
button on the receiver front panel.
OL-31085-01
About the Video Standard, page 1-1
Quick Setup Instructions, page 1-2
Rear Panel Connections, page 1-3
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
1
C H A P T E R
1-1