Cisco D9865 Installation And Configuration Manual page 116

Setting Up Dish Pointing
From the Service List Mode drop-down list, choose which tables to use to obtain tuning and channel
Step 4
lists.
Choose Rigorous if all the default settings must be present in the received signal.
Choose Degraded if only the table parameters present in the received signal will be used to install the
receiver. The default is Rigorous.
Step 5 The Service List Contributors area allows you to set up custom properties. The following table shows
some possible configurations for the allowed service lists and the different frequency tuning settings.
Allowed Service Lists
Bouquet Association Table (BAT) (not supported) N
Network Information Table (NIT)
Service Description Table (SDT)
Program Association Table (PAT)
Frequency Tuning mode
Note
Click OK.
Step 6
From the CA Mode drop-down list, choose the Conditional Access mode that determines which
Step 7
programs can be viewed via the receiver. You can select Std (preferred) or Open.
Caution
In the Network ID enter the network ID, obtained from your service provider.
Step 8
The SI Receive Status area displays all the current SI Receive settings. It also displays the source of last
Step 9
tuning, the last Preset Number activated, and the current settings of the allowed services (BAT, NIT,
SDT, PAT).
Click Apply.
Step 10
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
5-14
You cannot change the Bouquet Association Table value. It is not supported in the current
release.
In Open mode, the receiver ignores inconsistent scrambling descriptions within the signal.
Operating in this mode may cause the decoder not to respond to certain advanced uplink
controlled features, such as service replacement.
Chapter 5 Setup and Monitoring via Web GUI
Custom
N
N
Y
User Cfg
OL-31085-01