Genlock Reference; Setting Genlock Format - Cisco D9887B Installation And Configuration Manual

Genlock Reference

The Genlock Reference is only available when an MPEG-2/MPEG-4 4:2:0 D decoder
is installed in the unit. This sets the video format of the reference video that is being
used for Genlock.
To set the Genlock Reference on the unit, use the following steps:
1 Press the Menu button.
2 Use the Up and Down buttons to move the cursor to "Genlock Reference," then
press the Enter button.

Setting Genlock Format

To set the Genlock reference format, follow the steps below:
1 Use the Up and Down button to move the cursor to "Format," then press the
Enter button.
2 Use the Up and Down buttons to select the desired format, then press the Enter
button to save the selection.
Off
NTSC
PAL
720p
720p
720p
1080i
Note: The 1080p format selections are not available for the MPEG-2 Decoder 4:2:2
with Genlock (1 Video, 4 Audio) option.
78-4043743-01 Rev A
1080i
29.97 1080i
29.97 1080p
50.00 1080p
59.94 1080p
60.00 1080p
25.00 1080p
29.97
30.00
23.98 *
24.00 *
25.00 *
29.97 *
30.00 *

Genlock Reference

161