Appendix 2.3 Individual Contacts Of Each Unit - Hitachi CHROMASTER 5160 Instruction Manual

Appendix 2.3 Individual Contacts of Each Unit

(1) Contact Input Terminals
These are contact signal input terminals for control using
contact signals from an external switch, relay, etc. Any of
the signals is activated by shorting the terminal for 0.1
second or longer. The input circuit is shown in Appended
Fig. 2-3.
(2) Contact Signal Output Terminals
These are contact signal output terminals for control of an
external unit using contact signals. The output circuit is as
shown in Appended Fig. 1-20. The rating of contacts used
is 12 V, 0.1 A. Make sure the load connected does not
exceed this rating.
Chromaster series unit A
Appended Fig. 2-1 e-Line Cable Connection
IN
OUT 4.7k Ω
ON : 5 V
OFF : 0 V
Appended Fig. 2-2 e-Line Contact Circuit Configuration
APPENDIX 2 - 3
e-Line cable
Chromaster series unit B
+5 V
320 Ω
Max. 10 mA/unit
Max. 0.1 A
Other unit
＋
(H)
Max. 12 V (reverse
polarity prohibited)
(L) －
(G)