[Ed13] Front Alignment Plate Home Position Error - Toshiba e-STUDIO206L Service Manual

MJ-1106/1108
Check item
Movable tray paper-full sensor
Shutter
Shutter opening/closing sensor Check if there is a disconnection of the connector, incorrect
Shutter clutch
Parts to be replaced
Movable tray paper-full sensor
Finisher controller PC board
Shutter opening/closing sensor

[ED13] Front alignment plate home position error

Classification
Finisher jam
MJ-1101/1107
Check item
Front alignment plate
Front alignment motor
Front alignment plate home
position sensor
Finisher controller PC board
Parts to be replaced
Front alignment motor
Front alignment plate home
position sensor
Finisher controller PC board
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Measures
Fix any mechanical problem occurring when the actuator is moved.
Check if there is a disconnection of the connector, incorrect
installation or breakage of the movable tray paper-full sensor (S16).
If there is, reinstall the sensor correctly or replace it.
Check if the connector (CN12) on the finisher controller PC board is
disconnected from the movable tray paper-full sensor (S16) and the
harnesses are open circuited. Correct if so.
Open and close the shutter.
Fix any mechanical problem.
installation or breakage of the shutter opening/closing sensor (S4).
If there is, reinstall the sensor correctly or replace it.
Check if the connector (CN12) on the finisher controller PC board is
disconnected from the shutter opening/closing sensor (S4) and the
harnesses are open circuited. Correct if so.
Check if the connector (CN10) on the finisher controller PC board is
disconnected from the shutter clutch (CLT1) and the harnesses are
open circuited. Correct if so.
Remark
Error content
Front alignment plate home position error
Measures
Move the front alignment plate. If there is any mechanical problem,
fix its mechanism.
Check if the connectors on the finisher controller PC board are
disconnected from the front alignment plate home position sensor
(S7) and the front alignment motor (M9), or the harnesses are open
circuited. Correct if any.
Remark
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
8 - 111
ERROR CODE AND TROUBLESHOOTING
8