(31) Run the harness through the clamp. Then
run it through the hole in the equipment and
wire it to the front side as shown in the right-
hand figure.
(32) Connect 1 connector and install 3 clamps.
(33) Remove 1 screw and take off the duct.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-501
Fig. 4-502
Duct
Fig. 4-503
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
4 - 175
DISASSEMBLY AND REPLACEMENT
4