When A Normal Hdd Is Mounted - Toshiba e-STUDIO206L Service Manual

•

When a normal HDD is mounted

HDD Assist Mode
Current HDD type: SATA HDD
Select number (1-2) and press START key
1. Revert factory initial status HDD
2. Remove key
Remarks:
If the HDD type cannot be identified, "Unknown HDD" may appear on the screen.
Refer to  P. 8-202 " [F106_1] ADI-HDD error: HDD type detection error"
Note:
When "SATA HDD" (normal HDD) is displayed, items 1 and 2 are not selectable.
If you select any of 1 and 2 and press the [START] button, the error message below appears.
HDD Assist Mode
Current HDD type: SATA HDD
Select number (1-2) and press START key
=> 1. Revert factory initial status HDD
2. Remove key
Operation Failed.
Press SoftPower Key to Switch Off
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
SELF-DIAGNOSIS MODES
System Firmware Version
Update Mode
Fig.5-8
System Firmware Version
Update Mode
Fig.5-9
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
5 - 18
: xxxx(x.x.x.x)
: 4c Mode
: xxxx(x.x.x.x)
: 4c Mode