Upper Drawer Misfeeding (Paper Not Reaching The 1St Transport Sensor) - Toshiba e-STUDIO206L Service Manual

[E130] Upper drawer misfeeding (paper not reaching the 1st transport sensor)
Classification
Paper misfeeding
Proce
Check item
dure
1 Open the Automatic
duplexing unit. Is there
any paper in front of the
1st transport sensor?
2 Is the 1st transport sensor
working?
(Perform the input check
in the test mode: 03-
[FAX]OFF/[6]/[A])
3 Is the upper drawer feed
clutch working?
(Perform the output check
in the test mode: 03-201)
4 Upper drawer feed roller
Separation roller
Parts to be replaced
1st transport sensor.
LGC board
Upper drawer feed clutch
Upper drawer feed roller
Separation roller
Pickup roller
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Jam not reaching the 1st transport sensor
Result
Yes Remove the paper.
No
Yes
No • Check if the connector of the 1st transport
sensor is disconnected.
• Check if the connector CN316 on the LGC
board is disconnected.
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor pattern on the LGC
board is short circuited or open circuited.
• Replace the 1st transport sensor.
• Replace the LGC board.
Yes
No • Check if the connector of the upper drawer
feed clutch is disconnected.
• Check if the connector CN315 on the LGC
board is disconnected.
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor pattern on the LGC
board is short circuited or open circuited.
• Replace the upper drawer feed clutch.
• Replace the LGC board.
• Check the upper drawer feed roller,
separation roller and pickup roller.
Replace them if they are worn out.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
8 - 61
Error content
Measure
Remark
ERROR CODE AND TROUBLESHOOTING
Next
Step
2
3
8
4