Offset Tray Related Service Call; [Cdf0] Initialize Error Of The Offset Tray - Toshiba e-STUDIO206L Service Manual

8.3.20

Offset tray related service call

[CDF0] Initialize error of the offset tray (e-STUDIO206L/256/306 / 207L/257/307)
Classification
Offset tray related service call
Check Item
OCT motor
OCT board
LGC board
Replacement part
OCT motor
OCT board
LGC board
[CDF0] Initialize error of the offset tray (e-STUDIO356/456/506 / 357/457/507)
Classification
Offset tray related service call
Check Item
Offset gate motor
MOT2 board
LGC board
Replacement part
Offset gate motor.
MOT2 board
LGC board
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Initialize error of the offset tray
1. Check if each connector between the OCT motor and OCT
board (CN261) is disconnected.
2. Check if each connector between the OCT board (CN261)
and LGC board (CN302) is disconnected.
3. Check if each connector pin is removed or the harness is
broken.
4. Check if any conductor pattern on the OCT board and LGC
board is short circuited or open circuited.
Initialize error of the offset tray
1. Check if each connector between the offset gate motor and
MOT2 board (CN406) is disconnected.
2. Check if each connector between the MOT2 board (CN406)
and LGC board (CN302) is disconnected.
3. Check if each connector pin is removed or the harness is
broken.
4. Check if any conductor pattern on the MOT2 board and LGC
board is short circuited or open circuited.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
8 - 191
Contents
Measure
Measure
Contents
Measure
Remark
ERROR CODE AND TROUBLESHOOTING
8