Toshiba e-STUDIO206L Service Manual page 975

Notes:
• "Update Failed." is displayed at the bottom of the LCD screen when the updating is not
completed properly. "Failed" appears next to the failed item on the status display. Even
though an update fails, do not turn the power OFF until other updates are finished. If "Update
Failed" appears at the bottom of the screen, turn OFF the power and then check the following
items. After confirming and clearing the problems, restart updating from the beginning.
- Do the USB media meet the conditions to be used for updating?
- Is the data file written properly on the USB media?
- Are the USB media installed properly?
- Do the USB media and equipment operate properly?
• The integrity check system is automatically operated before firmware updating. During this
operation, "Verifying Signature..." and "Progress: **%" are displayed on the control panel.
When the check is completed properly, no message for notifying the success will appear and
the firmware updating will start. If it fails, "Invalid Signature" and "Copy Data with valid
signature in USB" will be shown. In that case, firmware updating cannot be performed, so turn
the power OFF and disconnect the USB device. Check the following, and reperform the
update.
- Check that the firmware data is not corrupted.
- Check that the signature file is not corrupted.
- Check that the combination of the firmware data and the signature file is correct.
• When an OS update error or HDD update error occurs, "Update Failed" or "Failed" appears
on the screen and the error number appears next to the message.
For details of each error, refer to the following tables.
Error number
O01 FROM writing failed
O02 FROM verification error
O03 File operation error
O04 SRAM flag set error
O05 Electronic key data backup error
O06 Device error
Error number
H01 File creation error
H02 File decompression error
H03 Partition mount error
H04 Hard disk full error
H00 Other errors
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
OS update Error
Error content
HDD update Error
Error content
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
11 - 19
FIRMWARE UPDATING
11