Toshiba e-STUDIO206L Service Manual page 343

Procedure 7
[0][5] [Digital key]
(Code)
[POWER]
*[CANCEL] or [CLEAR]
* When the automatic adjustment ends abnormally, error message is displayed.
Procedure 10
[0][5] [Digital key]
[POWER] (Code)
Procedure 12
[CANCEL]
[0][5]
[Digital key]
[ ] (Code)
POWER
Procedure 17
[CANCEL] or [CLEAR]
[0][5]
[Digital key]
[START]
[POWER]
(Code)
* The automatic adjustment starts when 2 minutes have passed after the [START] button is
pressed.
Notes:
The fuser roller temperature control at the adjustment mode is different from that at the normal
state.
Therefore, the problem of fusing efficiency may be occurred in the test copy at the adjustment
mode. In that case, turn ON the power normally, leave the equipment for approx. 3 minutes after
it has become ready state and then start up the adjustment mode again.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
[CANCEL]
( Automatic
[START]
adjustment
[Digital key]
[START]
(Sub code)
[OK] or [INTERRUPT]
(Value unchangeable)
[CLEAR]
[Digital key]
[START]
(key in a value)
[CLEAR]
(Corrects value)
[UP]
or Automatic
(
[DOWN] adjustment
(Adjust a value)
5 - 11
[OK]
)
Stores value
( )
[START]
in RAM
(Test copy)
Value
( )
[START]
displayed
([START]) [OK]
or
[INTERRUPT]
(Stores value in RAM)
[OK]
[UP]
or
or
)
[INTERRUPT]
[DOWN]
Stores value
(Adjust a value)
in RAM
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
[FAX]
[POWER]
OFF/ON
(Exit)
[POWER]
[START] OFF/ON
(Exit)
[POWER]
OFF/ON
(Exit)
[FAX]
[POWER]
OFF/ON
[STAR T]
(Exit)
(Test copy)
SELF-DIAGNOSIS MODES
5