[E726] Transport/exit signal reception jam
Classification
RADF jam
Check item
RADF board
SLG board
Switching power supply
Parts to be replaced
RADF board
SLG board
Switching regulator
[E731] Stop jam at the exit sensor
Classification
RADF jam
Check item
Exit roller
Exit sensor
RADF board
Parts to be replaced
Exit sensor
RADF board
Exit roller
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Transport/exit signal reception jam
•
Board check
•
Connector check
•
Harness check
•
Board check
•
Connector check
•
Harness check
•
Check if the 24V and 5V outputs of the switching power supply
are normal.
•
Board check
•
Connector check
•
Harness check
Error content
Stop jam at the exit sensor
Measures
Clean the registration roller if it is stained.
•
Sensor check
(Perform the input check: 03-[FAX] ON[7]/[E])
•
Connector check (CN74)
•
Harness check
•
Board check
•
Connector check (CN74)
•
Harness check
Remark
Replace it if it is worn out.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
8 - 83
Error content
Measures
Remark
ERROR CODE AND TROUBLESHOOTING
8