Oct Cover Opened During Printing - Toshiba e-STUDIO206L Service Manual

[E491] OCT cover opened during printing
Classification
Cover open jam
Proce
Check item
dure
1 Is the OCT cover open?
Is the OCT cover switch
2
working?
(Perform the input check
in the test mode: 03-
[FAX]ON/[3]/[E])
3 Replacing board
Parts to be replaced
OCT cover switch
OCT board.
LGC board
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
ERROR CODE AND TROUBLESHOOTING
Offset tray cover open jam
Result
Yes Remove the paper if there is any, then close
the cover
No
Yes
No • Check if the connector of the OCT cover
switch is disconnected?
• Check if either of the connectors CN260 or
CN261 on the OCT board is disconnected.
• Check if the connector CN302 on the OCT
board is disconnected.
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor patterns on the OCT
board and LGC board are short circuited or
open circuited.
• Replace the OCT cover switch.
• Replace the OCT board.
• Replace the LGC board.
• Replace the OCT board.
• Replace the LGC board.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 74
Error content
Measure
Remark
Next
Step
2
3