[Cb13] Finisher Exit Motor (M11) Abnormality; [Cb14] Paper Pusher Arm Motor (M10) Abnormality - Toshiba e-STUDIO206L Service Manual

MJ-1101/1107
Check Item
Buffer roller
Buffer roller drive motor (M6)
Replacement part
Buffer roller drive motor (M6)
Finisher controller PC board
MJ-1106/1108
Check Item
Buffer roller
Buffer roller drive motor
Replacement part
Buffer roller drive motor
Finisher controller PC board

[CB13] Finisher exit motor (M11) abnormality

MJ-1101/1107/MJ-1106/1108
Classification
Finisher related service call
Check item
Exit roller
Exit motor (M11).
Finisher control board
Replace parts
Exit motor
Finisher control board

[CB14] Paper pusher arm motor (M10) abnormality

MJ-1101/1107/MJ-1106/1108
Classification
Finisher related service call
Check item
Paper pusher cam
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
If there is mechanical problem when the buffer roller is
rotated, fix the mechanism.
Check the connectors and harnesses between the buffer
roller drive motor (M6) and the finisher control PC board
(CN18).
Rotate the buffer roller.
Fix any mechanical problem.
Check if the connector (CN11) on the finisher controller PC
board is disconnected from the buffer roller drive motor (M4)
and the harnesses are open circuited. Correct if so.
• Is there any mechanical problem when the exit roller is
rotated?
• Motor check
• Connector check
• Harness check
• Connector check (CN13)
• Board check
• Is there any mechanical problem when the paper pusher
cam is rotated?
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
8 - 157
Measure
Measure
Measure
Measure
Error item
Measures
Remarks
Error item
Measures
ERROR CODE AND TROUBLESHOOTING
8