Replace Sram Board; Initialize Sram System Storage Area - Toshiba e-STUDIO206L Service Manual

(2) Key in [1] to select "1. Backup SRAM Data to USB", and then press the [START] button.
(3) Enter a password (max. 15 characters) to be set for the backup data.
(4) Turn the power OFF after the backup is completed.
[B] Return License
(1) Start up with the Setting Mode (08).
(2) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [OK] button without entering anything.)
(3) Key in [3840], and then press the [OK] button.
(4) Select the license to be returned, and then press the [REMOVE] button.
(5) Install the one-time dongle, which you used for uploading the selected license, in the equipment,
and then press the [OK] button.
(6) The Remove screen is displayed, then press the [YES] button. If this screen is not displayed,
check whether the one-time dongle is installed in the equipment properly.
(7) After 10 to 40 seconds passes, the screen for notifying the success of performance is displayed.
Then press the [OK] button. If this screen is not displayed or the screen for notifying the failure of
performance is displayed, quit this operation by pressing the [NO]/[CLOSE] button. Then, check
whether the one-time dongle, which you used for uploading the selected license, is installed in
the equipment.
(8) Check that the returned license is not displayed on the screen.
Remarks:
If there are any other licenses to be returned, repeat from step (4).
If there is no more licenses to be returned, press the [CLOSE] button, and then turn the power
OFF.
[C] Replace SRAM board
(1) Confirm that the power is turned OFF.
(2) e-STUDIO206L/256/306/356/456/506: If the FAX unit (GD-1250) is installed, disconnect the
connector (CN134).
e-STUDIO207L/257/307/357/457/507: If the FAX unit (GD-1350) is installed, disconnect the USB
connector (CN117).
(3) Replace the SRAM board.
 P. 9-7 "9.1.9 SRAM board"
[D] Initialize SRAM system storage area
(1) Turn the power ON while pressing [6] and [CLEAR] simultaneously.
(2) When "SRAM Clear Mode" appears on the LCD, key in [1] to select "1. Clear SRAM" and then
press the [START] button.
(3) When "SRAM Format Completed" is displayed on the LCD, initializing is completed.
(4) Turn the power OFF.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
REPLACEMENT OF HDD/PC BOARDS
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
9 - 32