Toshiba e-STUDIO206L Service Manual page 656

MJ-1101/1107
Check item
Entrance sensor
Transport sensor
Parts to be replaced
Entrance sensor
Transport sensor
Finisher controller PC board
MJ-1106/1108
Check item
Finisher
Entrance sensor (S1)
Transport sensor (S2)
Processing tray sensor (S12)
Paper holding cam
Assist arm motor (M10)
Buffer tray guide
buffer tray guide motor (M2)
Finisher control PC board
(FIN)
Parts to be replaced
Entrance sensor (S1)
Transport sensor (S2)
Processing tray sensor (S12)
Assist arm motor (M10)
buffer tray guide motor (M2)
Finisher control PC board
(FIN)
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
ERROR CODE AND TROUBLESHOOTING
Measures
• Sensor check(S1)
• Connector check (CN7, CN22)
• Harness check
• Sensor check(S2)
• Connector check (CN7, CN22)
• Harness check
Remark
Measures
Check if there is any paper in the finisher or on the transport path of
the equipment and remove it if there is.
• Sensor check
• Connector check
• Harness check
• Sensor check
• Connector check
• Harness check
• Sensor check
• Connector check
• Harness check
Is there any mechanical problem when the paper holding cam is
rotated?
• Motor check
• Connector check
• Harness check
Open and close the buffer tray guide.
If there is any mechanical problem, fix its mechanism.
• Motor check
• Connector check
• Harness check
• Board check
• Connector check (CN6, CN13, CN11, CN18, CN26)
• Harness check
Remark
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 96