[Cc93] Knurled Roller Shift Solenoid Abnormality; [Cc94] Fan Motor Abnormality; [Cde0] Paddle Motor Abnormality - Toshiba e-STUDIO206L Service Manual

[CC93] Knurled roller shift solenoid abnormality

MJ-1032
Error
Knurled roller shift solenoid (SOL3)
2nd transport motor (M4)
Knurled roller home position sensor
(S10)

[CC94] Fan motor abnormality

Error
Fan motor (M10)

[CDE0] Paddle motor abnormality

* You receive a [CDE0] error when the [ED15] error occurs three times in succession or during the
initial operation.
Classification
Finisher related service call
MJ-1101/1107
Check Item
Paddle
Paddle motor
Replacement part
Paddle motor
Finisher control PC board
MJ-1106/1108
Check Item
Paddle
Paddle motor (M8)
Replacement part
Paddle motor (M8)
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Timing of detection
The knurled roller home position sensor (S10) does not detect that the
knurled roller is at the upper position after the 2nd transport motor (M4)
has been driven at the specified number of pulses during the initial
rising movement of the knurled roller.
The knurled roller home position sensor (S10) does not detect that the
knurled roller is not at the upper position after the 2nd transport motor
(M4) has been driven at the specified number of pulses during the
initial lowering movement of the knurled roller.
The knurled roller home position sensor (S10) does not detect that the
knurled roller is at the upper position when the pressurization of stack
exit movement is finished.
Timing of detection
The turning ON of the fan locking signal is detected consistently after
the specified time*.
*
A locking signal is not monitored from the start driving the motor until
the specified time has passed.
Paddle motor abnormality: The paddle motor is not rotating or
the paddle is not rotating normally.
Rotate the paddle.
Fix any mechanical problem.
Check the connectors and harnesses between the paddle
motor (M8) and the finisher control PC board (CN6).
Rotate the paddle.
Fix any mechanical problem.
Check if the connector (CN22) on the finisher controller PC
board is disconnected from the paddle motor (M3) and the
harnesses are open circuited. Correct if so.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
8 - 189
Contents
Measure
Measure
Measure
Measure
ERROR CODE AND TROUBLESHOOTING
8