System Control Pc Board (Sys Board) - Toshiba e-STUDIO206L Service Manual

9.2 Installation and Replacement of PC boards <e-STUDIO207L/
257/307/357/457/507>
Notes:
• When the PC board/HDD is replaced, refer to the respective Notes and Cautions of
"Replacement of PC board and HDD" in  P. 9-16 "9.3 Precautions and Procedures for
Replacing PC Boards and HDD".
• If the PC board has to be replaced due to an operational defect, this may have been caused
by a contact failure of the connector. Before replacing the board, disconnect and then
reconnect the connector to check if this action eliminates the operational defect.
9.2.1

System control PC board (SYS board)

(1) Take off the rear cover.
( P. 4-12 "4.2.6 Rear cover").
(2) Remove 1 screw, take off the ground plate
[1].
(3) Disconnect 13 connectors.
(4) Remove 8 screws and then take off the SYS
board [2].
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
REPLACEMENT OF HDD/PC BOARDS
Fig. 9-21
Fig. 9-22
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
9 - 8