[Ed11] Sideways Adjustment Motor (M2) Home Position Detection Error; [Ed12] Shutter Home Position Error - Toshiba e-STUDIO206L Service Manual

Check item
Skew adjustment motor
Skew HP sensor
Skew adjustment motor
Hole punch control PC board
Parts to be replaced
Skew adjustment motor
Hole punch control PC board

[ED11] Sideways adjustment motor (M2) home position detection error

MJ-1101 (when MJ-6103 is installed), MJ-1107 (when MJ-6104 is installed)
Classification
Finisher jam
Check item
Sideways adjustment motor
sideways deviation HP sensor
Sideways adjustment motor
Hole punch control PC board
Parts to be replaced
Sideways adjustment motor
Hole punch control PC board

[ED12] Shutter home position error

Classification
Finisher jam
MJ-1101/1107
Check item
Shutter
Shutter opening/closing sensor
Shutter clutch
Finisher controller PC board
Parts to be replaced
Shutter clutch
Shutter opening/closing sensor
Finisher controller PC board
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
ERROR CODE AND TROUBLESHOOTING
Measures
Rotate skew adjustment motor and fix its mechanism if it does not
rotate smoothly.
Check if the connectors on the hole punch controller PC board (HP
board) are disconnected from the skew HP sensor (S2) and the
skew adjustment motor, or the harnesses are open circuited.
Correct if any.
Remark
Error content
Sideways adjustment motor (M2) home position detection error
Measures
Rotate sideways adjustment motor and fix its mechanism if it does
not rotate smoothly.
Check if the connectors on the hole punch controller PC board (HP
board) are disconnected from the sideways deviation HP sensor
(S3) and the sideways adjustment motor, or the harnesses are open
circuited. Correct if any.
Remark
Error content
Shutter home position error
Measures
Open and close the shutter. If there is any mechanical problem, fix
its mechanism.
Check if the connectors on the finisher controller PC board are
disconnected from the shutter opening/closing sensor (S4) and the
shutter clutch (CLT1), or the harnesses are open circuited. Correct
if any.
Remark
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 110