Confirmation Of The Updated Data - Toshiba e-STUDIO206L Service Manual

11.7 Confirmation of the updated data

After the updating is completed, check each data version in Setting Mode (08) to confirm that the data
were overwritten properly.
Firmware
Updating Master data
(HDD program data)
Updating System ROM
(OS data)
Updating Engine ROM
(Engine firmware)
Updating Scanner ROM
(Scanner firmware)
Updating RADF ROM
(RADF firmware)
Updating Finisher ROM
Updating FAX ROM
The installed ROM versions and the registered optional Electronic License Keys can be confirmed in
the list print mode following the procedure below.
(1) Turn the power ON using the main power switch while pressing the digital key [9] and the
[START] button simultaneously.
* When the equipment is already in the other setting mode, press the [ON/OFF] button on the
control panel instead of using the main power switch.
(2) Key in "1" three times, and then press the [START] button.
(3) "VERSION LIST" is printed out.
* It is recommended to keep this list for future reinstallation such as the replacement of the SYS
board.
(4) Keep pressing the [ON/OFF] button until you hear a sound to shut down the equipment.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Code
08-8952 HD data external version
08-9900 System software version
08-9930 System ROM version
08-9901 Engine ROM version
08-9902 Scanner ROM version
08-9903 RADF ROM version
08-9904 Finisher ROM version
08-9944 Hole punch unit ROM version
08-9945 Converter board ROM version
08-9905 FAX ROM version
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
11 - 81
Remarks
FIRMWARE UPDATING
11