Honda Accord 2008 Manual page 2206

07/11/02 09:35:03 61TA0000_220_0176
Door Key Cylinder Switch Test
1. Remove the driver's door panel (see page 20-16).
2. Disconnect the 10P connector (A) from the door
lock actuator (key cylinder switch) (B).
＊０１
B
A
3. Check for continuity between the terminals.
• There should be continuity between the No. 9
and No. 5 terminals when the door key cylinder
switch is in LOCK position. (With security)
• There should be no continuity between the No. 9
and No. 5 terminals when the door key cylinder
switch is in the neutral or UNLOCK position.
(With security)
• There should be continuity between the No. 8
and No. 5 terminals when the door key cylinder
switch is in UNLOCK position.
• There should be no continuity between the No. 8
and No. 5 terminals when the door key cylinder
switch is in the neutral or LOCK position.
4. If the continuity is not as specified, replace the door
latch/actuator assembly (see page 20-23).
ＴＡ０８Ａ００Ｊ４６６４３４２０７０３ＦＥＡＴ００
Hood Switch Test
1. Open the hood.
2. Disconnect the 2P connector from the hood switch.
3. Check for continuity between the terminals.
• There should be continuity between the No. 1
and No. 2 terminals when the hood is opened
(latch released).
• There should be no continuity between the No. 1
and No. 2 terminals when the hood is closed
(latch pushed down).
4. If the continuity is not as specified, replace the
hood latch assembly (see page 20-283).
ＴＡ０８Ａ００Ｊ４６６４３４３２３０１ＦＥＡＴ００
＊０１
22-173 22-173