Honda Accord 2008 Manual page 2117

07/11/02 09:29:19 61TA0000_220_0087
Under-dash Fuse/Relay Box
Driver's Under-dash Fuse/Relay Box (MICU) Removal/Installation
USA models
NOTE: SRS components are located in this area.
Review the SRS component locations 4-door (see page
24-19), 2-door (see page 24-21), and precautions and
procedures (see page 24-23) before doing repairs or
servicing.
Removal
1. Do the battery terminal disconnection procedure
(see page 22-89).
2. Remove the driver's dashboard lower cover
(see page 20-152), and the left kick panel:
• 4-door (see page 20-99)
• 2-door (see page 20-97)
3. Disconnect the connectors from the fuse side of the
driver's under-dash fuse/relay box (A).
＊０１
4. Remove the mounting bolt, and pull the driver's
under-dash fuse/relay box away from the body.
5. Disconnect the connectors from the back side of the
driver's under-dash fuse/relay box, then remove
the driver's under-dash fuse/relay box.
6. Carefully remove the relays by prying under the
base of the relay.
NOTE: Do not use pliers. Pliers will damage the
relays, which could cause the engine to stall or not
start.
22-84
A
Installation
1. Install the relays and connect the connectors to the
driver's under-dash fuse/relay box, then install the
driver's under-dash fuse/relay box in the reverse
order of removal.
2. Install the removed parts in the reverse order of
removal.
3. Do the battery terminal reconnection procedure
steps 1 to 4 (see page 22-89).
4. Register the immobilizer system with the HDS
(see page 22-410).
NOTE: The imoes unit is built into the driver's MICU
which is part of the driver's under-dash fuse/relay
box. Because of this construction, the imoes must
be registered, or the vehicle will not start.
5. Do the remaining steps of battery terminal
reconnection procedure (see page 22-89).
6. Confirm that all systems work properly.
ＴＡ０８Ａ００Ｊ５４２２６５６２０１１ＫＤＡＴ００