Honda Accord 2008 Manual page 2126

07/11/02 09:29:23 61TA0000_220_0096
2. If any of these relays fails the test, replace the relay
circuit board.
A/C condenser fan relay
There should be continuity between the C1 and C3
terminals when battery power is connected to the
B11 terminal, and body ground is connected to the
B7 (or B8) terminal. There should be no continuity
between the C1 and C3 terminals when power is
disconnected.
Wiper motor relay circuit test:
There should be continuity between the C4 and B10
terminals, and C4 and B12 terminals when battery
power is connected to the B9 terminal, and body
ground is connected to the B3 terminal. There
should be no continuity between the C4 and B10
terminals, and C4 and B12 terminals when power is
disconnected.
Wiper intermittent relay circuit test:
There should be battery voltage between the C5
terminal and body ground when battery power is
connected to the B9 and C4 terminals, and body
ground is connected to the B3 and B12 terminals.
There should be no voltage between the C5
terminal and body ground when the B12 terminal is
disconnected.
Wiper high/low relay circuit test:
There should be continuity between the B3 and C2
terminals when battery power is connected to the
B9 and C4 terminals, and body ground is connected
to the B3 and B10 terminals.
There should be no continuity between the B3 and
C2 terminals, and there should be continuity
between the B3 and C5 terminals when power is
disconnected.
A/C condenser fan relay
B11 C1
A/C
CONDENSER
FAN RELAY
B7, B8
C3
Wiper motor relay, Wiper intermittent relay, Wiper
high/low relay
B9 C4
WIPER
MOTOR
RELAY
WIPER
INTERMITTENT
RELAY
B3 C5 C2
B12
WIPER
HIGH/LOW
RELAY
B10
22-93
＊０７
＊０８