07/11/02 09:39:36 61TA0000_220_0299
Wipers/Washers
MICU Input Test (cont'd)
Passenger's MICU
6. Turn the ignition switch to LOCK (0), and remove the right kick panel.
• 2-door (see page 20-97)
• 4-door (see page 20-99)
7. Disconnect passenger's under-dash fuse/relay box connectors A, E, G and H .
1: LX, LX PZEV, LX , LX
2: Except LX, LX PZEV, LX , LX
NOTE: All connector views are wire side of female terminals.
*02
8. With the connectors still disconnected, make these input tests at the connectors.
• If any test indicates a problem, find and correct the cause, then recheck the system.
• If all the input tests prove OK, go to step 9.
Cavity
E9
22-296
+
+
PZEV, LX-S, LX-S PZEV
+
+
PZEV, LX-S, LX-S PZEV
CONNECTOR A (33P)
PNK
BRN
CONNECTOR E (18P)
GRN
BLK
Wire
Test condition
GRN
Ignition switch ON (II)
1
2
CONNECTOR G (16P)
(LX, LX PZEV, LX , LX
LX-S, LX-S PZEV)
CONNECTOR H (38P)
(Except LX, LX PZEV, LX ,
LX
+
PZEV, LX-S, LX-S PZEV)
BLK
Test: Desired result
Connect the A31 and the E9 terminals:
The washer motor should run.
+
+
PZEV,
BLK
+
Possible cause if desired result is not
obtained
•
Poor ground (G201)
•
Faulty washer motor
•
An open in the wire